I have disabled IPv6, either systemwide or on the Tun/TAP interface, and OpenVPN exits out with a fatal error.Įdit the OpenVPN configuration and make the following changes: OpenVPN exits with a fatal error after I've disabled IPv6 Add mkdir /run/resolvconf/ directly after the header on the first line that starts without a hash (#) sign.It shows "mkdir: cannot create directory '/etc/resolvconf/run': File exists in the error logs." If this does not work, lower the mssfix number to 1300 and then retry. Save the edited file and restart the OpenVPN service.Įdit C:\program files\openvpn\config\mullvad_ (or C:\program files (x86)\openvpn\config\mullvad_) by adding "mssfix 1332" to it, then save and retry. Edit /etc/openvpn/mullvad_nf and add "mssfix X" where X is the value from the previous step.Take your MTU size from step 3 and subtract 40 from it.Once you see Message too long,look at the size on the previous working reply and that will be your MTU.Increase the size (1300) each time as long as you are receiving replies.While connected to Mullvad, open a terminal and issue ping -M do -s 1300 -c 1 8.8.8.8.Edit OSX/Mullvad.tblk/mullvad_osx.conf and add "mssfix X" where X is the number from step 3.Change directory to the newly extracted one.Extract mullvadconfig.zip to a temporary directory.Take your MTU size from step 2 and subtract 40 from it.Once you see Message too long, look at the value on the line above and that will be your MTU.While you are connected to Mullvad, open a terminal and issue ping -i 0.1 -D -g 1300 -G 1500 8.8.8.8.Pinging and using HTTP websites work, but HTTPS websites do not. Install the Re-enable IPv6 on nontunnel interfaces and on IPv6 tunnel interfaces fix from Microsoft.If it is set to 0xFF, then change it to 0x00.Open regedit and navigate to HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip6\Parameters\DisabledComponent. Make sure that you have Internet Protocol version 6 enabled on your TAP adapter.Wed Aug 29 22:01:11 2018 ERROR: netsh command failed: returned error code 1 Ipv6 set address interface=11 store=active I use Windows and can't connect to any server.ĭoes your logfile contain the following? Wed Aug 29 22:01:11 2018 NETSH: C:\WINDOWS\system32\netsh.exe interface
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |